ETHERLINK (3C501; ASSY.#1221) Network Card Settings and Configuration

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	8-bit ISA
Topology	Linear Bus
Wiring Type	RG-58A/U 50ohm coaxial AUI transceiver via DB-15 port
Boot ROM	Available

CABLE TYPE SELECTION
Type		Setting
»	RG-58A/U 50ohm coaxial	Option 1
	AUI transceiver via DB-15 port	Option 2

BOOT ROM CONFIGURATION
Setting		JP3
»	Disabled	Pins 2 & 3 Closed
	Enabled	Pins 1 & 2 Closed

I/O BASE ADDRESS SELECTION
Address	JP4	JP5	JP6	JP7	JP8	JP9
300h	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 1 & 2	Pins 1 & 2
310h	Pins 1 & 2	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 1 & 2	Pins 1 & 2
Note:Pins designated should be in the closed position.

BOOT ROM ADDRESS SELECTION
Address	JP12	JP13	JP14	JP15	JP16	JP17	JP18	JP19
CC000h	Pins 2&3	Pins 2&3	Pins 1&2	Pins 1&2	Pins 2&3	Pins 2&3	Pins 1&2	Pins 1&2
EC000h	Pins 2&3	Pins 2&3	Pins 1&2	Pins 1&2	Pins 2&3	Pins 1&2	Pins 1&2	Pins 1&2
Note:Pins designated should be in the closed position.

INTERRUPT REQUEST SELECTION
IRQ	JP20	JP21	JP22	JP23	JP24	JP25
2	Closed	Open	Open	Open	Open	Open
3	Open	Closed	Open	Open	Open	Open
4	Open	Open	Closed	Open	Open	Open
5	Open	Open	Open	Closed	Open	Open
6	Open	Open	Open	Open	Closed	Open
7	Open	Open	Open	Open	Open	Closed

DMA CHANNEL SELECTION
Channel	JP26	JP27	JP28	JP29	JP30	JP31
DMA1	Closed	Open	Open	Closed	Open	Open
DMA2	Open	Closed	Open	Open	Closed	Open
DMA3	Open	Open	Closed	Open	Open	Closed
Note:Setting the DMA Channel on this card is required even though "No Channel" is listed when setting up the LAN configuration software.