U-1496E/U-1496E+ modem/telephone/ISDN Settings and Configuration
ZYXEL COMMUNICATIONS CORPORATION
U-1496E/U-1496E+
Modem Type | Data (synchronous/asynchronous)/Fax/Voice |
Maximum Data Rate | 19.2Kbps |
Maximum Fax Rate | 14.4Kbps |
Data Bus | External |
Fax Class | Class I & II |
Data Modulation Protocol | Bell 103A/212A CCITT V.21, V.22, V.22bis, V.23, V.26bis, V.27bis, V.29, V.32, V.32bis, V.33 ZyXEL 16.8Kbps, 19.2Kbps, ZyCELL 4800bps-19.2Kbps cellular |
Fax Modulation Protocol | ITU-T V.17, V.21CH2, V.27ter, V.29 |
Error Correction/Compression | MNP2-5, V.42, V.42bis |
CONNECTIONS | |||
Purpose | Location | Purpose | Location |
Line out | CN1 | DC power | CN3 |
Line in | CN2 | RS-232/422 | CN4 |
DIAGNOSTIC LED(S) | |||
LED | Color | Status | Condition |
HS | Red | On | Modem is in 9600bps or faster mode. |
HS | Red | Off | Modem is in slower than 9600bps mode. |
HS | Red | Blinking | Modem is retraining speed. |
AA | Red | On | Auto-answer enabled |
AA | Red | Off | Auto-answer disabled |
AA | Red | Blinking | Line is ringing |
CD | Red | On | Carrier signal has been detected. |
CD | Red | Off | Carrier signal has not been detected. |
OH | Red | On | Modem is off-hook |
OH | Red | Off | Modem is on-hook |
DTR | Red | On | DTR signal is high |
DTR | Red | Off | DTR signal is low |
DSR | Red | On | DSR signal is high |
DSR | Red | Off | DSR signal is low |
CTS | Red | On | CTS signal is high |
CTS | Red | Off | CTS signal is low |
TXD | Red | On | Modem is transmitting data |
TXD | Red | Off | Modem is not transmitting data |
RXD | Red | On | Modem is receiving data |
RXD | Red | Off | Modem is not receiving data |
EC | Red | On | Modem is in error-correcting mode. |
EC | Red | Off | Modem is not in error-correcting mode. |
SQ | Red | On | Signal quality is good. |
SQ | Red | Off | Signal quality is poor; at power-up, indicates an error. |
TST | Red | On | Modem is in test mode. |
TST | Red | Off | Modem is not in test mode. |
Proprietary Command Set
See document V1036 for a full command summary.
My Books
