MPM-4 modem/telephone/ISDN Settings and Configuration

Card Type	Modem(asynchronous)
Chip Set	Unidentified
Maximum Data Rate	28.8Kbps
Maximum Fax Rate	N/A
Data Bus	16 bit ISA
Fax Class	N/A
Data Modulation Protocol	AT&T V.32terbo Bell 103A/212A ITU-T V.22, V.22bis, V.23, V.32, V.32bis, V.34
Fax Modulation Protocol	N/A
Error Correction/Compression	MNP5, V.42bis

CONNECTIONS
Function	Label		Function		Label
Line 1 out		CN1		Line 3 out		CN3
Line 2 out		CN2		Line 4 out		CN4

I/O PORT ADDRESS
Address	SW1
280h	0
2A0h	1
2C0h	2
2E0h	3
í 300h	4
320h	5
340h	6
360h	7
Not used	8
Not used	9
Note: Use the settings in this table only if the Xircom XMAPI driver is installed. Driver configures interrupt settings.

I/O PORT ADDRESS/INTERRUPT
Port 1	Port 2	Port 3	Port 4	SW1
3F8h, IRQ4	2F8h, IRQ3	3E8h, IRQ4	2E8h, IRQ3	A
1A0, IRQ10	1A8h, IRQ10	1B0h, IRQ10	1B8h, IRQ10	B
1A0, IRQ12	1A8h, IRQ12	1B0h, IRQ12	1B8h, IRQ12	C
2A0, IRQ10	2A8h, IRQ10	2B0h, IRQ10	2B8h, IRQ10	D
2A0, IRQ12	2A8h, IRQ12	2B0h, IRQ12	2B8h, IRQ12	E
Not used					F
Note: Use these settings if the Xircom driver is not installed