RAD DATA COMMUNICATIONS
SRM-9 (TB)
Card Type | Short Range Modem |
Chip Set | Unidentified |
I/O Options | 25-pin serial port (RS-232), Terminal block |
Wiring Type | Unshielded twisted pair |
Maximum Data Rate | 128Kbps (synchronous), 115.2Kbps (asynchronous) |
Data Bus | External |

CONNECTIONS | ||||||
Function | Label | Function | Label | |||
DTE/DCE serial port (25-pin connector) | CN1 | Twisted pair connection terminal blocks | CN2 | |||
USER CONFIGURABLE SETTINGS | ||
Setting | Label | Position |
Pattern (BERT) test activated | SW1/1 | On |
Pattern (BERT) test not activated | SW1/1 | Off |
Local digital loopback test activated | SW1/2 | On |
Local digital loopback test not activated | SW1/2 | Off |
Local analog loopback test activated | SW1/3 | On |
Local analog loopback test not activated | SW1/3 | Off |
Remote digital loopback test activated | SW1/4 | On |
Remote digital loopback test not activated | SW1/4 | Off |
DIAGNOSTIC LEDS | |||
LED | Color | Status | Condition |
TD | Unidentified | On | Device is transmitting data |
TD | Unidentified | Off | Device is not transmitting data |
RD | Unidentified | On | Device is receiving pulses from network |
RD | Unidentified | Off | Device is not receiving pulses from network |
RTS | Unidentified | On | RTS signal is high |
RTS | Unidentified | Off | RTS signal is low |
DCD | Unidentified | On | DCD signal is high |
DCD | Unidentified | Off | DCD signal is low |
ERR | Unidentified | On | Error detected on received data during BERT test |
ERR | Unidentified | Off | Error not detected on received configuration information |
TST | Unidentified | On | Device is conducting a loopback test |
TST | Unidentified | Off | Device is not conducting a loopback test |