PARADYNE CORPORATION
7612 SNMP DSU
Card Type | DSU |
Chip Set | Unidentified |
I/O Options | DTE/DCE port, network interface via RJ-48 connector, power jack, DTE port |
Wiring Type | RJ-45 Unshielded twisted pair T1 via RJ-48 |
Maximum Data Rate | 56Kbps (64Kbps full duplex or clear channel) |
Data Modulation Protocol | DDS, LADS, MIBII, SNMP |
Data Bus | External |
CONNECTIONS | |||
Function | Label | Function | Label |
Power Jack | CN1 | DTE port (V.35 connector) | CN4 |
DTE/DCE port (25-pin serial connector) | CN2 | Network interface via RJ-48 connector | CN5 |
RJ-45 UTP connector | CN3 |
DIAGNOSTIC LED(S) | |||
LED | Color | Status | Condition |
OK | Green | On | DSU power is on |
OK | Green | Off | DSU power is off, performing a self test, or detecting a system failure |
ALM | Red | On | DSU has detected an alarm condition |
ALM | Red | Off | DSU has not detected an alarm condition |
TST | Yellow | On | DSU is executing a test |
TST | Yellow | Off | DSU is not executing a test |
DM | Green | On | Data is being transmitted/received |
DM | Green | Off | CMI codes are being received |
OOS | Red | On | DSU is receiving an out of service code from remote unit |
OOS | Red | Off | DSU is not receiving an out of service code from remote unit |
OOF | Red | On | DSU is detecting an out of frame condition |
OOF | Red | Off | DSU is not detecting an out of frame condition |
NS | Red | On | Carrier signal not detected |
NS | Red | Off | Carrier signal detected |
TXD | Green | On | Receiving all zeros from the DTE |
TXD | Green | Off | Receiving all ones from the DTE |
TXD | Green | Blinking | Data is being transferred |
RXD | Green | On | Transmitting all zeros from the DTE |
RXD | Green | Off | Transmitting all ones from the DTE |
RXD | Green | Blinking | Data is being transferred |
RTS | Green | On | RTS signal is high |
RTS | Green | Off | RTS signal is low |
CTS | Green | On | CTS signal is high |
CTS | Green | Off | CTS signal is low |
DTR | Green | On | DTR signal is high |
DTR | Green | Off | DTR signal is low |