2814XV modem/telephone/ISDN Settings and Configuration
LOGICODE TECHNOLOGY, INC.
2814XV
Modem Type | Data (synchronous/asynchronous)/Fax |
Maximum Data Rate | 28.8Kbps |
Maximum Fax Rate | 14.4Kbps |
Data Bus | External |
Fax Class | Class I & II |
Data Modulation Protocol | Bell 103A/212A ITU-T V.21, V.22, V.22bis, V.32, V.32bis, V.34 |
Fax Modulation Protocol | ITU-T V.17, V.21CH2, V.27ter, V.29 |
Error Correction/Compression | MNP10, MNP5, V.42, V.42bis |
CONNECTIONS | |||
Purpose | Location | Purpose | Location |
Line out | CN1 | Speaker | CN5 |
Line in | CN2 | Microphone | CN6 |
RS-232/422 | CN3 | Power switch | SW1 |
DC power | CN4 | ||
SYNCHRONOUS/ASYNCHRONOUS OPERATION | ||
Setting | SW2/2 | SW2/3 |
Asynchronous operation | On | Off |
Synchronous with internal clock | On | Off |
Synchronous with external clock | Off | On |
Synchronous with slave clock | Off | Off |
DSR/DTR FORCED HIGH | |
| Setting | SW2/4 |
| » Normal operation | On |
| DSR/DTR forced high | Off |
COMMAND SET | |
Setting | SW2/6 |
V.25bis command set | Off |
AT command set | On |
REMOTE CONFIGURATION | |
Setting | SW2/7 |
Enabled | Off |
Disabled | On |
CALLBACK SECURITY | |
Setting | SW2/8 |
Disabled | Off |
Enabled | On |
FACTORY CONFIGURED SETTINGS | |
Switch | Setting |
Off | SW2/1 |
On | SW2/5 |
DIAGNOSTIC LED(S) | |||
LED | Icon | Status | Condition |
AA | AA | On | Auto-answer enabled |
AA | AA | Off | Auto-answer disabled |
AA | AA | Blinking | Phone is ringing |
ST | Pyramid of balls | On | Self test mode |
ST | Pyramid of balls | Off | Normal operation |
ST | Pyramid of balls | Blinking | Self test failure |
RX | Modem left arrow | On | Modem is receiving data |
RX | Modem left arrow | Off | Modem is not receiving data |
TX | Modem right arrow | On | Modem is transmitting data |
TX | Modem right arrow | Off | Modem is not transmitting data |
CD | Phone | On | Carrier signal detected |
CD | Phone | Off | Carrier signal not detected |
HS | Running figure | On | Modem is operating at 4800bps or faster |
HS | Running figure | Off | Modem is operating at slower than 4800bps |
OH | Crossed out phone | On | Modem is off-hook |
OH | Crossed out phone | Off | Modem is on-hook |
TR | Box | On | DTR signal is high |
TR | Box | Off | DTR signal is low |
MS | Box | On | Modem connected at more than 24Kbps |
MS | Box | Off | Modem connected at less than 24Kbps |
MR | Rectangle | On | Power is on |
MR | Rectangle | Off | Power is off |
Proprietary AT Command Set
See document V1268 for a full command summary.
My Books
