ELSA, INC.
MICROLINK 28.8TQV
Card Type | Modem (asynchronous) |
Chipset | Unidentified |
I/O Options | Voice |
Maximum Data Rate | 28.8Kbps |
Maximum Fax Rate | 14.4Kbps |
Data Modulation | Bell 103A, 212A ITU-T V.21, V.22, V.23, V.32, V.32bis, V.34 Rockwell V.FC |
Fax Modulation | ITU-T V.17, V.27ter, V.29, V.33 |
Error Correction/Compression | MNP5, V.42, V.42bis |
Fax Class | Class I & II |
Data Bus | Serial |
CONNECTIONS | |||
Function | Label | Function | Label |
Telephone line in | CN1 | DC power in | CN4 |
Telephone line out | CN2 | Power switch | SW1 |
Serial port | CN3 |
DIAGNOSTIC LED(S) | |||
LED | Color | Status | Condition |
POWER | Red | On | Power is on |
POWER | Red | Off | Power is off |
TXD | Red | On | Modem is transmitting data |
TXD | Red | Off | Modem is not transmitting data |
RXD | Red | On | Modem is receiving data |
RXD | Red | Off | Modem is not receiving data |
DTR | Red | On | DTR signal is high |
DTR | Red | Off | DTR signal is low |
DSR | Red | On | DSR signal is high |
DSR | Red | Off | DSR signal is low |
RTS | Red | On | RTS signal is high |
RTS | Red | Off | RTS signal is low |
DIAGNOSTIC LED(S) (CON'T) | |||
LED | Color | Status | Condition |
CTS | Red | On | CTS signal is high |
CTS | Red | Off | CTS signal is low |
DCD | Red | On | Carrier signal detected |
DCD | Red | Off | Carrier signal not detected |
OH | Red | On | Modem is off-hook |
OH | Red | Off | Modem is on-hook |
SUPPORTED STANDARD COMMANDS |
Basic AT Commands |
+++, ‘comma’, A/ |
A, B, E, H, L, M, O, P, T, V, X, Z |
&D, &F, &S, &T, &V, &W, &Y, &Z |
Extended AT Commands |
\C, \J, \K, \N, \Q, \T, \X |
%A, %C, %E |
Special AT Commands |
-J |
S-Registers |
S0, S1, S2, S3, S4, S5, S6, S7, S8, S10, S11, S12, S16, S21, S22, S25, S30, S38 |
Note: See MHI help file for complete information. |
Proprietary AT Command Set
See ELSA, INC. MICROLINK 33.6TQV for a full command summary.