EICON TECHNOLOGY CORPORATION
DIVA T/A ISDN MODEM
Card Type | ISDN Modem |
NIC Type | ISDN |
Maximum Onboard Memory | 4KB |
Boot ROM | Unavailable |
Network Transfer Rate | 230.4Kbps |
Topology | Star |
Wiring Type | RJ-45 ISDN BRI |
Data Bus | External |
![]()
CONNECTIONS | |||
Function | Label | Function | Label |
25-pin DTE serial port | CN1 | RJ-11 analog phone interface | PH1 |
Power connector | CN2 | RJ-11 analog phone interface | PH2 |
RJ-45 ISDN interface | ISDN | ||
USER CONFIGURABLE SETTINGS | ||
Setting | Label | Position |
Resistance set to 100Ohm (connection span >75meters) | SW1 | On |
Resistance set to 50Ohm (connection span <75meters) | SW1 | Off |
Note: Switch available on S/T models for Australia only. Termination requirements vary according to the number of devices connected to the NT1, and the distance between devices and NT1. | ||
DIAGNOSTIC LED(S) | |||
LED | Color | Status | Condition |
B1 | Unidentified | On | B-channel 1 connection is good |
B1 | Unidentified | Blinking | B-channel 1 connection is being established |
B1 | Unidentified | Off | B-channel 1 connection is broken |
B2 | Unidentified | On | B-channel 2 connection is good |
B2 | Unidentified | Blinking | B-channel 2 connection is being established |
B2 | Unidentified | Off | B-channel 2 connection is broken |
DT | Unidentified | On | ISDN interface is established. Data transmission is possible |
DT | Unidentified | Blinking | ISDN interface is initializing or error is occurring. Data transmission is not possible |
DT | Unidentified | Off | ISDN interface is not activated |
LNK | Unidentified | On | ISDN link is good |
LNK | Unidentified | Blinking | ISDN link is synchronizing |
LNK | Unidentified | Off | ISDN link is broken (In Europe this indicates idle status) |
P1 | Unidentified | On | Connection is good on voice channel 1 |
P1 | Unidentified | Blinking | Outgoing or incoming connection is being established on voice channel 1 |
P1 | Unidentified | Off | No activity on voice channel 1 |
P2 | Unidentified | On | Connection is good on voice channel 2 |
P2 | Unidentified | Blinking | Outgoing or incoming connection is being established on voice channel 2 |
P2 | Unidentified | Off | No activity on voice channel 2 |
TX-RX | Unidentified | Blinking | Data is being transmitted/received on serial port |
TX-RX | Unidentified | Off | Data is not being transmitted/received on serial port |
DTE | Unidentified | On | Serial port connection is good |
DTE | Unidentified | Blinking | Serial port connection is being established |
DTE | Unidentified | Off | Serial port connection is broken |
FAULT | Unidentified | On | Software fault condition detected |
FAULT | Unidentified | Blinking | Hardware fault condition detected |
FAULT | Unidentified | Off | ISDN modem is operating normally |
PWR | Unidentified | On | Power is on |
PWR | Unidentified | Off | Power is off |