MXE-2400SF modem/telephone/ISDN Settings and Configuration
CALPAK CORPORATION
MXE-2400SF
Modem Type | Data (synchronous/asynchronous)/Fax |
Maximum Data Rate | 2400bps |
Maximum Fax Rate | 9600bps |
Data Bus | External |
Fax Class | Unidentifed |
Data Modulation Protocol | Unidentifed |
Fax Modulation Protocol | ITU-T V.21, V.27ter |
CONNECTIONS | |||
Purpose | Location | Purpose | Location |
Line out | CN1 | RS-232/422 | CN3 |
Line in | CN2 | AC power | CN4 |
DIAGNOSTIC LED(S) | ||
LED | Status | Condition |
AA | On | Auto-answer enabled |
AA | Off | Auto-answer disabled |
RXD | On | Modem is receiving data |
RXD | Off | Modem is not receiving data |
TXD | On | Modem is transmitting data |
TXD | Off | Modem is not transmitting data |
CD | On | Carrier signal detected |
CD | Off | Carrier signal not detected |
OH | On | Modem is off-hook |
OH | Off | Modem is on-hook |
HS | On | Modem is operating at 2400bps |
HS | Off | Modem is operating at slower than 2400bps |
DTR | On | DTR signal is high |
DTR | Off | DTR signal is low |
MR | On | Power is on |
MR | Off | Power is off |
MODE | |
Settings | SW1/1 |
Dumb mode | On |
Normal mode | Off |
AUTO-ANSWER | |
Settings | SW1/2 |
Auto-answer enabled | On |
Auto-answer disabled | Off |
DCD | |
Settings | SW1/3 |
DCD normal | On |
DCD forced high | Off |
DTR | |
Settings | SW1/4 |
Reset ON DTR | On |
DTR ON to OFF | Off |
MISCELLANEOUS TECHNICAL NOTE |
Exact location of switches and LEDs is unidentified. |
Proprietary AT Command Set
See document V1558 for a full command summary.
My Books
