MX25 IO card Settings and Configuration

Card Type	X.25 PAD
Chip Set	Unidentified
I/O Options	Printer/diagnostic port
Transfer Rate	19.2Kbps
Data Bus	External

CONNECTIONS
Function	Label	Function	Label
RS-232 X.25 to DTE	CN1	Diagnostic/printer port	CN3
RS-232 to X.25 network transmission device	CN2	DC power	CN4

USER CONFIGURABLE SETTINGS
Setting		Label	Position
»	Hardware flow control is not being used	J401	Open
	Hardware flow control is being used	J401	Closed
»	Factory configured - do not alter	J201	Open
»	Factory configured - do not alter	J402	Open
»	Factory configured - do not alter	J403	Open
»	Factory configured - do not alter	J404	Open

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
ERR	Red	On	A fatal error has occurred (after initial start-up)
ERR	Red	Off	A fatal error has not occurred
RX1	Red	On	PAD is receiving data from DTE
RX1	Red	Off	PAD is not receiving data from DTE
TX1	Red	On	PAD is transmitting data to DTE
TX1	Red	Off	PAD is not transmitting data to DTE
HP	Red	On	PAD is waiting for an incoming call
HP	Red	Off	PAD is busy and not waiting for an incoming call
COMP	Red	On	X.25 link to network is good
COMP	Red	Off	X.25 link to network is not good
RX2	Red	On	PAD is receiving data from network
RX2	Red	Off	PAD is not receiving data from network
TX2	Red	On	PAD is transmitting data to network
TX2	Red	Off	PAD is not transmitting data to network
CONT	Red	On	X.25 call has connected
CONT	Red	Off	No X.25 call has connected
PWR	Red	On	Power is on
PWR	Red	Off	Power is off
Note:LEDs will blink during self-test sequence.