2085 IO card Settings and Configuration
PATTON ELECTRONICS COMPANY
2085
Card Type | Interface Converter |
Chip Set | Unidentified |
I/O Options | 25-pin serial port (RS-232), network interface via RJ-45, RJ-11, 25-pin port or terminal block |
Wiring Type | Unshielded twisted pair |
Maximum Data Rate | 115.2Kbps |
Data Bus | External |
CONNECTIONS | |||
Function | Label | Function | Label |
DTE/DCE serial port (25-pin connector) | CN1 | UTP interface | CN2 |
Note: Network interface (CN2) is available with several connector options. Device may feature a terminal block, RJ-11, RJ-45, or 25-pin (male or female) connector. | |||
USER CONFIGURABLE SETTINGS | ||
Setting | Label | Position |
DTE mode | S2 | On |
DCE mode | S2 | Off |
USER CONFIGURABLE SETTINGS | |||
Setting | Label | Position | |
| » | 8ms RTS/CTS delay enabled | S1/3 | On |
| RTS/CTS delay disabled | S1/3 | Off | |
| » | Echo mode disabled | S1/4 | Off |
Echo mode enabled | S1/4 | On | |
| » | Carrier controlled by RTS | S1/5 | On |
Carrier forced high | S1/5 | Off | |
| » | Receive impedance set low (120Ohms) | S1/6 | On |
Receive impedance set high (16kOhms) | S1/6 | Off | |
TRANSMIT LINE IMPEDENCE | |||
Setting | S1/1 | S1/2 | |
| » | High impedence enabled | Off | Off |
Intermediate impedence enabled | On | On | |
2-WIRE/4-WIRE MODE SELECTION | |||
Setting | S1/7 | S1/8 | |
| » | 2-wire mode enabled | On | On |
4-wire mode enabled enabled | Off | Off | |
My Books
