Hard Drive: NEC: D1632 85MB PCMCIA III PCMCIA ATA

D 1 6 3 2    NEC
                                                      Native|  Translation
                                                      ------+-----+-----+-----
Form                 PCMCIA TYPE III       Cylinders        |  977|     |
Capacity form/unform    85/      MB        Heads           4|   10|     |
Seek time   / track  16.0/     ms          Sector/track     |   17|     |
Controller           PCMCIA / ATA          Precompensation
Cache/Buffer            32 KB              Landing Zone
Data transfer rate    4.500 MB/S int       Bytes/Sector      512
                            MB/S ext
Recording method                                    operating  | non-operating
                                                  -------------+--------------
Supply voltage     5 V          Temperature *C         5 55    |    -40 60
Power: sleep              W     Humidity     %         8 80    |      8 80
       standby            W     Altitude    km                 |
       idle           0.6 W     Shock        g        20       |    200
       seek           1.5 W     Rotation   RPM      5400
       read/write     1.5 W     Acoustic   dBA
       spin-up        3.0 W     ECC        Bit
                                MTBF         h     100000
                                Warranty Month
Lift/Lock/Park     YES          Certificates

Jumpers

NEC IDE/AT JUMPER CONFIGURATION

Jumper Setting
==============

 Jumper Konfiguration I1
 -----------------------
    +--------------+---------------+-------------+
    |Single Drive  | Master Drive  | Slave Drive |
    +--------------+---------------+-------------+
    |JP12 OPEN     | JP12 CLOSED   | JP12 CLOSED |
    |JP13 OPEN     | JP13 OPEN     | JP13 CLOSED |
    +--------------+---------------+-------------+

 Jumper Konfiguration I2
 -----------------------
    +--------------+---------------+-------------+
    |Single Drive  | Master Drive  | Slave Drive |
    +--------------+---------------+-------------+
    |JP12 CLOSED   | JP12 OPEN     | JP12 OPEN   |
    |JP13 CLOSED   | JP13 CLOSED   | JP13 OPEN   |
    +--------------+---------------+-------------+

 Jumper Konfiguration I3
 -----------------------
    +--------------+---------------+-------------+
    |Single Drive  | Master Drive  | Slave Drive |
    +--------------+---------------+-------------+
    |MST CLOSED    | MST CLOSED    | MST OPEN    |
    |SLV OPEN      | SLV OPEN      | SLV CLOSED  |
    |TRS CLOSED    | TRS CLOSED    | TRS CLOSED  |
    +--------------+---------------+-------------+

Jumper Konfiguration I4
-----------------------

 +--------+ON
 |x x x x |     Single Drive
 +1-2-3-4-+OFF

 +--------+ON
 |x x x x |     Master Drive
 +1-2-3-4-+OFF

 +--------+ON
 |x x x x |     Slave Drive
 +1-2-3-4-+OFF

 +--------+ON
 |x x x x |     Or you use the Cable Select signal, Master/Slave is
 +1-2-3-4-+OFF  always the same (see below).

 Jumper Konfiguration I5
 -----------------------
 +-----------------+----------------+----------------+
 |Single Drive     |Master Drive    |Slave Drive     |
 +-----------------+----------------+----------------+
 |Pin 47/48 CLOSED |Pin 47/48 CLOSED| Pin 47/48 OPEN |
 +-----------------+----------------+----------------+