D Y K A - 2 3 2 4 0 T R A V E . 3 G N IBM
Native| Translation
------+-----+-----+-----
Form 2.5"/SUPERSLIMLINE Cylinders | 6304| |
Capacity form/unform 3240/ MB Heads | 16| |
Seek time / track 13.0/ 4.0 ms Sector/track | 63| |
Controller IDE / ATA3 Precompensation
Cache/Buffer 90 KB Landing Zone
Data transfer rate 7.000 MB/S int Bytes/Sector 512
33.300 MB/S ext DMA
Recording method operating | non-operating
-------------+--------------
Supply voltage 5 V Temperature *C 5 55 | -40 65
Power: sleep 0.1 W Humidity % 8 90 | 5 95
standby 0.3 W Altitude km -0.300 3.000| -0.300 12.000
idle 1.5 W Shock g 125 |
seek 2.3 W Rotation RPM 4200
read/write 2.0 W Acoustic dBA
spin-up 4.7 W ECC Bit ENHANCED, ON THE FLY,SMART
MTBF h
Warranty Month 24
Lift/Lock/Park YES Certificates
IBM DYKA-22160/23240 TRAVELSTAR JUMPER SETTING
+--------------------------------------+
| |
| |
| |
+--------Interface-------------49------+
| **********************1 **47 Jumper
| *************x********* **48 |
+------44----------------------50------+
+ +
Pin position 20 is left blank for secure connector insertion.
Pin position 49: When grounded, no spin-up at POR when open/pull up,
normal spin-up at POR.
IBM DYKA-22160/23240 TRAVELSTAR 3GN JUMPER SETTING
Jumper Setting
==============
Drive Address Setting
---------------------
A jumper is available at the interface connector to determine the
drive address. Using Cable Selection, the drive address depends on
the condition of pin 28 of the AT interface cable. In the case when
pin 28 is ground or low, the drive is a Master. If pin 28 is open or
high level, the drive is a Slave.
---49--47+
* * * | Master
* * * | (Default setting)
---50--48+
---49--47+
* * X | Slave
* * X |
---50--48+
---49--47+
* * * | Cable Selection
* xxx |
---50--48+
---49--47+
* xxx | RESERVED (MASTER)
* * * |
---50--48+
---49--47+
* X * | NEVER ATTACH A JUMPER HERE!
* X * |
---50--48+
49-PIN: When grounded, no spin-up at POR
When open/pull-up, normal spin-up at POR