Hard Drive: IBM: DPRA-21215 TRAVEL.XP 1200MB 2.5"/SSL ATA2 FAST

D P R A - 2 1 2 1 5   T R A V E L . X P    IBM
                                                      Native|  Translation
                                                      ------+-----+-----+-----
Form                 2.5"/SUPERSLIMLINE    Cylinders        | 2358|     |
Capacity form/unform  1200/      MB        Heads            |   16|     |
Seek time   / track  12.0/ 4.0 ms          Sector/track     |   63|     |
Controller           IDE / ATA2 FAST/ENHA  Precompensation
Cache/Buffer            64 KB READ/WRITE   Landing Zone
Data transfer rate    5.000 MB/S int       Bytes/Sector      512
                     11.100 MB/S ext PIO3
Recording method                                    operating  | non-operating
                                                  -------------+--------------
Supply voltage     5 V          Temperature *C         5 55    |    -40 65
Power: sleep          0.1 W     Humidity     %         8 90    |      5 95
       standby        0.3 W     Altitude    km    -0.300  3.000| -0.300 12.000
       idle           1.3 W     Shock        g       100       |    300
       seek           2.6 W     Rotation   RPM      4900
       read/write     2.6 W     Acoustic   dBA
       spin-up            W     ECC        Bit   128BIT REED SOLOMON,ENHANC...
                                MTBF         h     300000
                                Warranty Month
Lift/Lock/Park     YES          Certificates                                  

Layout

IBM DPRA-20810/21215 TRAVELSTAR XP JUMPER SETTING

              +--------------------------------------+
              |                                      |
              |                                      |
              |                                      |
              +--------Interface-------------47------+
              |       **********************1 **45 Jumper
              |       *************x********* **46   |
              +------44----------------------48------+
              +                                      +

Pin position 20 is left blank for secure connector insertion.

Pin position 45 through 48 are used for drive address setting.

Jumpers

IBM DPRA-20810/21215 JUMPER SETTING

Jumper Setting
==============

Drive address
-------------
A jumper is available at the interface connector to determine the
drive address.

Using Cable Selection, the drive address depends on the condition of
pin 28 of the AT interface cable. In the case when pin 28 is ground
or low, the drive is a Master. If pin 28 is open or high level, the
drive is a Slave.

   ---47--45+
    *   * X | Master
    *   * X | (Default setting)
   ---48--46+

   ---47--45+
    *   * * | Slave
    *   * * | No Jumper
   ---48--46+

   ---47--45+
    *   * * | Cable Selection
    *   xxx |
   ---48--46+

Install

-ANY DIREC.

Notes on installation
=====================

Installation direction
----------------------

     horizontally                           vertically
   +-----------------+             +--+                       +--+
   |                 |             |  +-----+           +-----+  |
   |                 |             |  |     |           |     |  |
 +-+-----------------+-+           |  |     |           |     |  |
 +---------------------+           |  |     |           |     |  |
                                   |  |     |           |     |  |
                                   |  |     |           |     |  |
 +---------------------+           |  +-----+           +-----+  |
 +-+-----------------+-+           +--+                       +--+
   |                 |
   |                 |
   +-----------------+

The drive will operate in all axis (6 directions).