Hard Drive: IBM: DPLA-25120 TRAVE.5GS 5120MB 2.5"/SSL ATA3

D P L A - 2 5 1 2 0   T R A V E . 5 G S    IBM
                                                      Native|  Translation
                                                      ------+-----+-----+-----
Form                 2.5"/SUPERSLIMLINE    Cylinders        |10592|     |
Capacity form/unform  5120/      MB        Heads            |   15|     |
Seek time   / track  12.0/ 4.0 ms          Sector/track     |   63|     |
Controller           IDE / ATA3            Precompensation
Cache/Buffer            96 KB              Landing Zone
Data transfer rate    9.000 MB/S int       Bytes/Sector      512
                     16.600 MB/S ext
Recording method                                    operating  | non-operating
                                                  -------------+--------------
Supply voltage     5 V          Temperature *C         5 55    |        65
Power: sleep          0.1 W     Humidity     %         8 90    |      5 95
       standby        0.3 W     Altitude    km    -0.300  3.000| -0.300 12.000
       idle           1.3 W     Shock        g       100       |    400
       seek               W     Rotation   RPM      4900
       read/write     2.5 W     Acoustic   dBA
       spin-up        5.0 W     ECC        Bit
                                MTBF         h
                                Warranty Month
Lift/Lock/Park     YES          Certificates                                  

Layout

IBM DPLA TRAVELSTAR 5GS JUMPER SETTING

              +--------------------------------------+
              |                                      |
              |                                      |
              |                                      |
              +--------Interface-------------49------+
              |       **********************1 **47 Jumper
              |       *************x********* **48   |
              +------44----------------------50------+
              +                                      +

Pin position 20 is left blank for secure connector insertion.

Jumpers

IBM DPLA-24480/25120 TRAVELSTAR 5GS JUMPER SETTING

Jumper Setting
==============

Drive Address Setting
---------------------
A jumper is available at the interface connector to determine the
drive address.

Using Cable Selection, the drive address depends on the condition of
pin 28 of the AT interface cable. In the case when pin 28 is ground
or low, the drive is a Master. If pin 28 is open or high level, the
drive is a Slave.

   ---49--47+
    *   * * | Master
    *   * * | (Default setting)
   ---50--48+

   ---49--47+
    *   * X | Slave
    *   * X |
   ---50--48+

   ---49--47+
    *   * * | Cable Selection
    *   xxx |
   ---50--48+

   ---49--47+
    *   xxx | RESERVED       (MASTER)
    *   * * |
   ---50--48+

   ---49--47+
    *   X * | NEVER ATTACH A JUMPER HERE!
    *   X * |
   ---50--48+

Install

-ANY DIREC.

Notes on installation
=====================

Installation direction
----------------------

     horizontally                           vertically
   +-----------------+             +--+                       +--+
   |                 |             |  +-----+           +-----+  |
   |                 |             |  |     |           |     |  |
 +-+-----------------+-+           |  |     |           |     |  |
 +---------------------+           |  |     |           |     |  |
                                   |  |     |           |     |  |
                                   |  |     |           |     |  |
 +---------------------+           |  +-----+           +-----+  |
 +-+-----------------+-+           +--+                       +--+
   |                 |
   |                 |
   +-----------------+

The drive will operate in all axis (6 directions).