Hard Drive: IBM: DLGA-23080 TRAVE.3XP 3080MB 2.5"/SSL ATA2 FAST

D L G A - 2 3 0 8 0   T R A V E . 3 X P    IBM
                                                      Native|  Translation
                                                      ------+-----+-----+-----
Form                 2.5"/SUPERSLIMLINE    Cylinders        | 5968|     |
Capacity form/unform  3080/      MB        Heads           8|   16|     |
Seek time   / track  12.0/ 4.0 ms          Sector/track     |   63|     |
Controller           IDE / ATA2 FAST/ENHA  Precompensation
Cache/Buffer            96 KB              Landing Zone
Data transfer rate    5.500 MB/S int       Bytes/Sector      512
                     16.600 MB/S ext PIO4
Recording method                                    operating  | non-operating
                                                  -------------+--------------
Supply voltage     5 V          Temperature *C         5 55    |    -40 65
Power: sleep          0.1 W     Humidity     %         8 90    |      5 95
       standby        0.3 W     Altitude    km    -0.300  3.048| -0.300 12.000
       idle           1.1 W     Shock        g       100       |    500
       seek           2.6 W     Rotation   RPM      4000
       read/write     2.6 W     Acoustic   dBA
       spin-up        6.0 W     ECC        Bit   ENHANCED, ON THE FLY,SMART
                                MTBF         h
                                Warranty Month
Lift/Lock/Park     YES          Certificates                                  

Layout

IBM DLGA-22690/23080 TRAVELSTAR 3XP

              +--------------------------------------+
              |                                      |
              |                                      |
              |                                      |
              +--------Interface-------------49------+
              |       **********************1 **47 Jumper
              |       *************x********* **48   |
              +------44----------------------50------+
              +                                      +

Pin position 20 is left blank for secure connector insertion.

Jumpers

IBM DLGA/DSOA

Jumper Setting
==============

A jumper cable is available at the interface connector to determine
drive address.

Using cable selection, the drive address depends on the condition
of pin 28 of the AT interface cable. In the case when pin 28 is
ground or low, the drive is a master. If pin 28 is open or high
level, the drive is a slave.

 DLGA
 +----------------------------------------------49--47
 | * * * * * * * * * * * * * * * * * * * * * * * * * |
 | * * * * * * * * * * * *   * * * * * * * * * * * * |
 +----------------------------------------------50--48

 ------49--47
        * * |  No jumper = MASTER
        * * |
 ------50--48

 ------49--47
        * X |
        * X |  SLAVE
 ------50--48

 ------49--47
        * * |
        xxxx|  CABLE SELECTION
 ------50--48

 ------49--47
        xxxx|
        * * |  RESERVED (=MASTER)
 ------50--48

 ------49--47
        X * |
        X * |  NEVER ATTACH A JUMPER HERE!!!
 ------50--48