D E S K S T A R 5 3 6 8 4 0 IBM Native| Translation ------+-----+-----+----- Form 3.5"/SLIMLINE Cylinders |12592|12592| Capacity form/unform 6840/ MB Heads 8| 16| 15| Seek time / track 9.1/ ms Sector/track | 63| 63| Controller IDE / ATA3 Precompensation Cache/Buffer 476 KB ADAPTIVE Landing Zone Data transfer rate MB/S int Bytes/Sector 512 16.600 MB/S ext PIO4 Recording method operating | non-operating -------------+-------------- Supply voltage 5/12 V Temperature *C 5 55 | -40 65 Power: sleep W Humidity % 8 90 | 5 95 standby W Altitude km -0.300 3.048| -0.300 12.000 idle W Shock g 10 | 75 seek W Rotation RPM 5400 read/write W Acoustic dBA spin-up W ECC Bit SMART MTBF h Warranty Month Lift/Lock/Park YES Certificates UL478
IBM DESKSTAR 5 JUMPER SETTING
+---------------------------------------------------------------+ | | | | | +--------------------------------------1---G-----A-+------1-+ | | |* * * * * * * * * * * * * * * * * * * * * * * * * |X X X X | | | |* * * * * * * * * * * * * * * * * * *+-+* * * * |X X X X | | +-+------AT-INTERFACE---------------------+ +-JUMPER-+-POWER--+-+
IBM DESKSTAR 5 JUMPER SETTING
Jumper Setting
==============
Interface Connector 3M 3417-7000 or equivalent
16 Logical Head 15 Logical Head
--------------- ---------------
G E C A G E C A
X * * X Device 0 X * xxx
X * * X (Master) X * * *
H F D B H F D B
G E C A G E C A
* * X X Device 1 * * xxx
* * X X (Slave) * * * *
H F D B H F D B
G E C A G E C A
* X * X Cable Select * X xxx
* X * X * X * *
H F D B H F D B
G E C A G E C A
X * * X Device 1 X X * *
X * * X (Slave) X X * *
H F D B Present H F D B
All other jumper setting patterns are reserved. Do not make other
settings.
Shipping default settings:
16 head logical architecture is enabled. Master is set to on (i.e.
jumper on pins A-B and G-H. No other jumpers are fitted.
IBM DESKSTAR 5 NOTES ON INSTALLATION
Notes on installation
=====================
Installation direction
----------------------
horizontally vertically +-----------------+ +--+ +--+ | | | +-----+ +-----+ | | | | | | | | | +-+-----------------+-+ | | | | | | +---------------------+ | | | | | | | | | | | | | | | | | | +---------------------+ | +-----+ +-----+ | +-+-----------------+-+ +--+ +--+ | | | | +-----------------+
The drive will operate in all axis (6 directions).
Mount the drive securely, using the appropriate brackets or rails, in
any axis, using four 6-32 UNC metric screws in either bottom or side
mounting holes.
The max. screw insertion depth for the bottom mounting is 5.5mm
(0.21 inch) and for side mounting 3.5 mm (0.14 inch).