WD1007V-MC1 Hard Disk/Floppy Controller Settings and Configuration
WESTERN DIGITAL CORPORATION
WD1007V-MC1
Data bus: 16-bit, MCA PS/2 system
Size: Full-length card
Hard drives supported: 2 ESDI drives
Floppy drives supported: None
CONNECTIONS | |
Function | Location |
20-pin data cable connector-drive 1 | J2 |
20-pin data cable connector-drive 2 | J3 |
34-pin control cable connector-hard drive | J4 |
MISCELLANEOUS TECHNICAL NOTES |
There are no user-configurable jumpers on the WD1007V-MC1, all configuration is done through the firmware. Each WD1007V-MC1 board can support two hard disks. If two WD1007V-MC1 boards are installed in a PS/2 system only one drive may be attached to each controller. (i.e.: you can never have more than a maximum of two hard drives in a PS/2 system, no matter how many controller cards are installed.) The ESDI drive is always assigned to C:. If you have one ESDI and one ST506/412 drive, the MCA architecture always selects the ESDI drive as drive C:. |
My Books
