FSIO-UC3 (V1.1) Hard Disk/Floppy Controller Settings and Configuration

Data Bus	16-bit ISA
Card Size	Half-length, half-height card
Hard Drives supported	Two IDE (AT) drives
Floppy drives supported	Two 360KB, 720KB, 1.2MB, or 1.44MB drives

CONNECTIONS
Function	Location	Function	Location
40-pin IDE(AT) connector	CN1	10-pin serial port 2 - internal	CN5
34-pin cable connector - floppy drive	CN2	25-pin parallel port - external	CN6
16-pin game port	CN3	4-pin connector - drive active LED	J2
10-pin serial port 1 - internal	CN4
Note: The location of J2 is unidentified.

USER CONFIGURABLE SETTINGS
Function		Label	Position
	IOCHRDY signal disabled	J1	Closed
	IOCHRDY signal enabled	J1	Open
	Serial port 2 enabled	JP2	Pins 1 & 2 closed
	Serial port 2 disabled	JP2	Pins 2 & 3 closed
	Game port enabled	JP3	Pins 1 & 2 closed
	Game port disabled	JP3	Pins 2 & 3 closed
»	Factory configured - do not alter	JP4	Unidentified
	Parallel port I/O address is 378-37Fh	JP5	Pins 1 & 2 closed
	Parallel port I/O address is 278-27Fh	JP5	Pins 2 & 3 closed
	Serial port 1 enabled	JP6	Pins 1 & 2 closed
	Serial port 1 disabled	JP6	Pins 2 & 3 closed
	Floppy drive interface enabled	JP7	Pins 1 & 2 closed
	Floppy drive interface disabled	JP7	Pins 2 & 3 closed
»	Factory configured - do not alter	JP8	Unidentified
	IDE(AT) interface enabled	JP9	Pins 1 & 2 closed
	IDE(AT) interface disabled	JP9	Pins 2 & 3 closed
»	Factory configured - do not alter	JP10	Unidentified