IDE-V4-022 Hard Disk/Floppy Controller Settings and Configuration
UNIDENTIFIED
IDE-V4-022
Data bus: | 16-bit, ISA |
Size: | Half-length, half-height card |
Hard drive supported: | Two IDE (AT) Interface drives |
Floppy drives supported: | Two 360KB, 720KB, 1.2MB, or 1.44MB drives |
CONNECTIONS | |
Function | Location |
40-pin IDE(AT) Interface connector | CN1 |
34-pin control cable connector - floppy drive | CN2 |
2-pin connector - Drive Active LED | CN3 |
USER CONFIGURABLE SETTINGS | |||
Function | Location | Setting | |
| » | Floppy drive enabled | JP1 | pins 2 & 3 closed |
Floppy drive disabled | JP1 | pins 1 & 2 closed | |
| » | Hard drive enabled | JP2 | pins 2 & 3 closed |
Hard drive disabled | JP2 | pins 1 & 2 closed | |
| » | Floppy drive port address is 3F0-3F7h | JP3 | pins 1 & 2 closed |
Floppy drive port address is 370-377h | JP3 | pins 2 & 3 closed | |
| » | Floppy drive order (A;/B:) normal | JP4 | pins 2 & 3 closed |
Floppy drive order (A;/B:) reversed | JP4 | pins 1 & 2 closed | |
| » | Hard drive port address is 1F0-1F7 & 3F6-3F7h | JP5 | pins 1 & 2 closed |
Hard drive port address is 170-177 & 376-377h | JP5 | pins 2 & 3 closed | |
| » | IRQ14 enabled | JP8 | closed |
IRQ14 disabled | JP8 | open | |
My Books
