IDE/FDC MULTI I-O Hard Disk/Floppy Controller Settings and Configuration

Data bus:	16-bit, ISA
Size:	Half-length, full-height card
Hard drive supported:	Two IDE (AT) Interface drives
Floppy drives supported:	Two 360KB, 720KB, 1.2MB, or 1.44MB drives

CONNECTIONS
Function	Location
25 pin parallel port-external	CN1
10 pin serial port 1-internal	CN2
10 pin serial port 2-internal	CN3
40 pin IDE(AT) interface connector	CN4
34 pin data cable connector-floppy drive interface	CN5
2 pin connector-drive active LED	LED

USER CONFIGURABLE SETTINGS
Purpose		Jumper	Setting
»	Floppy drive interface enabled	JP1	pins 1 & 2 closed
	Floppy drive interface disabled	JP1	pins 2 & 3 closed
»	Parallel port address LPT2 select	JP2	pins 1 & 2 closed
	Parallel port address LPT3 select	JP2	pins 2 & 3 closed
»	Serial port 1 address select 3F8h	JP3	pins 1 & 2 closed
	Serial port 1 address select 3E8h	JP3	pins 2 & 3 closed
»	Serial port 2 address select 2F8h	JP4	pins 1 & 2 closed
	Serial port 2 address select 2E8h	JP4	pins 2 & 3 closed
»	Hard Drive interface enabled	JP5	pins 1 & 2 closed
	Hard Drive interface disabled	JP5	pins 2 & 3 closed
»	Factory configured-do not alter	JP6	pins 1 & 2 closed