PCI-MAX Hard Disk/Floppy Controller Settings and Configuration

Data bus:	32-bit PCI
Size:	Half-length, full-height card
Hard drive supported:	Four EIDE drives
Floppy drives supported:	None

CONNECTIONS
Function	Location
40-pin primary IDE(AT) connector	JP2
40-pin secondary IDE(AT) connector	JP3
4-pin connector - drive active LED	JP23

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Factory configured - do not alter	JP6	closed
»	Factory configured - do not alter	JP7	open
Note: The number of pins in JP6 is unidentified.

BIOS ADDRESS SELECTION
Address		JP4	JP5
»	D800h	pins 2 & 3 closed	pins 2 & 3 closed
	C800h	pins 2 & 3 closed	pins 1 & 2 closed
	D000h	pins 1 & 2 closed	pins 2 & 3 closed
	Disabled	pins 1 & 2 closed	pins 1 & 2 closed
Note: The location of pin 1 in JP4 & JP5 is unidentified.

PRIMARY IDE PCI INTERRUPT SLECTION
INT	JP16	JP17	JP18	JP19
A	closed	open	open	open
B	open	closed	open	open
C	open	open	closed	open
D	open	open	open	closed
Note: IRQ 14 is used for these settings.

SECONDARY IDE PCI INTERRUPT SLECTION
INT	JP15	JP20	JP21	JP22
A	closed	open	open	open
B	open	closed	open	open
C	open	open	closed	open
D	open	open	open	closed
Note: IRQ 15 is used for these settings.

MISCELLANEOUS TECHNICAL NOTES

BIOS on board is optional. In versions without BIOS the settings for JP4 & JP5 are different.