IDE INTERFACE ADAPTER Hard Disk/Floppy Controller Settings and Configuration

Card Type	Hard drive controller card
Processor	None
Maximum Onboard Memory	Unidentified
Hard Drives supported	(2) IDE (AT/XT)
Floppy drives supported	None
Data Bus	8-bit ISA
Card Size	Half length, half height

CONNECTIONS
Function	Location	Function	Location
40-pin primary IDE(AT) connector	JP1	4-pin connector - drive active LED	JP4

USER CONFIGURABLE SETTINGS
Function		Label	Position
»	IDE(AT) interface enabled	JP2	Open
	IDE (XT) interface enabled	JP2	Closed
»	Adapter enabled	JP3	Closed
	Adapter disabled	JP3	Open
»	Pass diagnostics disabled	JP10	Open
	Pass diagnostics enabled	JP10	Closed
»	System signal ‘ALE’ disabled	JP11	Open
	System signal ‘ALE’ enabled	JP11	Closed
»	System signal ‘AEN’ disabled	JP12	Open
	System signal ‘AEN’ enabled	JP12	Closed

EPROM JUMPER CONFIGURATION
EPROM		Bank Selection	JP8	JP9
	2764	4000	Pins 2 & 3 closed	Pins 1 & 2 closed
»	27256	0000	Pins 2 & 3 closed	Pins 2 & 3 closed
		2000	Pins 1 & 2 closed	Pins 2 & 3 closed
		4000	Pins 2 & 3 closed	Pins 1 & 2 closed
		6000	Pins 1 & 2 closed	Pins 1 & 2 closed

BIOS ADDRESS SELECTION
Address	JP6	JP7
C8000h	Pins 2 & 3 closed	Pins 2 & 3 closed
CA000h	Pins 1 & 2 closed	Pins 2 & 3 closed
CC000h	Pins 2 & 3 closed	Pins 1 & 2 closed
CE000h	Pins 1 & 2 closed	Pins 1 & 2 closed