DC-320E Hard Disk/Floppy Controller Settings and Configuration
TEKRAM TECHNOLOGY COMPANY, LTD.
DC-320E
Data Bus | 32-bit EISA |
Card Size | Half-length, full-height card |
Hard Drives supported | Up to seven Fast SCSI drives |
Floppy drives supported | Two 360KB, 720KB, 1.2MB, 1.44MB, or 2.88MB drives |
CONNECTIONS | |||
Function | Location | Function | Location |
50-pin SCSI connector - external | CN1 | 2-pin connector - drive active LED | JP1 |
50-pin SCSI connector - internal | CN2 | 4-pin connector - speaker | JP2 |
34-pin cable connector - floppy drive | CN3 | ||
Note: Speaker connector JP2 is used for warning beeps. | |||
USER CONFIGURABLE SETTINGS | |||
Function | Label | Position | |
| » | Floppy drive interface enabled | JP3 | Closed |
| Floppy drive interface disabled | JP3 | Open | |
DIAGNOSTIC LED SETTINGS | |
Status | Condition |
One short flash | Error in on-board CPU |
Two short flashes | Error in on-board SCSI chip |
Three short flashes | Error in on-board bus master protocol chip |
Four short flashes | SRAM error |
Four short flashes | EPROM checksum error |
My Books
