lotus



previous page: DC-600CF Hard Disk/Floppy Controller Settings and Configuration
  
page up: Hard Disk/Floppy Controller Specs: S-T
  
next page: DC-680CD Hard Disk/Floppy Controller Settings and Configuration

DC-600T Hard Disk/Floppy Controller Settings and Configuration






TEKRAM TECHNOLOGY CO., LTD.

DC-600T

Data bus:

16-bit, ISA

Size:

Three/quarter-length, full-height card

Hard drive supported:

Four IDE (AT) Interface drives

Floppy drives supported:

Two 360KB, 720KB, 1.2MB, or 1.44MB drives

CONNECTIONS

Function

Location

40-pin IDE (AT) Interface connector - IDE-0

CN1

40-pin IDE (AT) Interface connector - IDE-1

CN2

34-pin control cable connector - floppy drive

CN3

4-pin connector - drive active LED

JP1

4-pin connector - cache error speaker

JP2

USER CONFIGURABLE SETTINGS

Function

Location

Setting

IDE-0 damping resistor enabled

JDR0

open

 

IDE-0 damping resistor disabled

JDR0

closed

IDE-1 damping resistor enabled

JDR1

open

 

IDE-1 damping resistor disabled

JDR1

closed

BIOS ADDRESS

Address

JP3/jumper 1

JP3/jumper 2

JP3/jumper 3

DC000h

closed

closed

closed

 

DC000h

closed

closed

open

 

D8000h

closed

open

closed

 

D4000h

closed

open

open

 

D0000h

open

closed

closed

 

CC000h

open

closed

open

 

C8000h

open

open

closed

 

Disabled

open

open

open

USER CONFIGURABLE SETTINGS

Function

Location

Setting

Floppy drive enabled

JP3/jumper 4

closed

 

Floppy drive disabled

JP3/jumper 4

open

Hard drive port address is 1F0-1F7h

JP3/jumper 5

closed

 

Hard drive port address is 170-177h

JP3/jumper 5

open

MISCELLANEOUS TECHNICAL NOTES

At least one SIMM memory module (256KB, 1MB, or 4MB) must be installed in order for the controller to function. Different sizes can be mixed in any combination.








TOP
previous page: DC-600CF Hard Disk/Floppy Controller Settings and Configuration
  
page up: Hard Disk/Floppy Controller Specs: S-T
  
next page: DC-680CD Hard Disk/Floppy Controller Settings and Configuration