OMTI 510, OMTI 510-HA-3, OMTI 510-HA-7 Hard Disk/Floppy Controller Settings and Configuration

Data bus:	8-bit, ISA
Size:	Half-length, half-height card
Hard drive supported:	Up to seven SCSI devices
Floppy drives supported:	None

CONNECTIONS
Function	Location
50-pin SCSI connector - internal	J1
37-pin SCSI connector - external (OMTI512 only)	J2

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	SCSI Busy signal enabled	W1	pins 2 & 3 closed
	SCSI Busy signal disabled	W1	pins 1 & 2 closed
»	SCSI Message signal enabled	W2	pins 2 & 3 closed
	SCSI Message signal disabled	W2	pins 1 & 2 closed
»	SCSI parity check enabled	W4	pins 2 & 3 closed
	SCSI parity check disabled	W4	pins 1 & 2 closed

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	BIOS enabled	W7	open
	BIOS disabled	W7	closed
»	BIOS address is C800h	W8	open
	BIOS address is CA00h	W8	closed
»	28-pin EPROM type enabled	W9 and W10	pins 1 & 2 closed
	24-pin EPROM type enabled	W9 and W10	pins 2 & 3 closed*
»	SCSI Receive parity disabled	W11	pins 1 & 2 closed
	SCSI Receive parity enabled	W11	pins 2 & 3 closed
Note: Cut the foil trace between pins 1 & 2 on Jumpers W9 and W10 if closing pins 2 & 3

I/O PORT ADDRESS
Address		Jumper W6	Jumper W5
»	320h	open	open
	324h	open	closed
	328h	closed	open
	32Ch	closed	closed

MISCELLANEOUS TECHNICAL NOTES

Jumper W3 is not used and should remain factory configured with pins 1 & 2 in the closed position. Do not disable SCSI Busy and Message signals (Jumpers W1 and W2)