LCS-6624/B (UM-6624-B00) Hard Disk/Floppy Controller Settings and Configuration

Card Type	Hard drive controller card
Hard Drives supported	Two IDE (AT) drives
Floppy drives supported	Two 360KB, 720KB, 1.2MB, or 1.44MB drives
Data Bus	16-bit ISA
Card Size	Half-length, half-height card

CONNECTIONS
Function	Location	Function	Location
34-pin cable connector - floppy drive	J1	9-pin serial port 1 - external	J5
40-pin primary IDE(AT) connector	J2	25-pin parallel port - external	J6
16-pin game port	J3	2-pin connector - drive active LED	JP1
10-pin serial port 2 - internal	J4

USER CONFIGURABLE SETTINGS
Function		Label	Position
»	Hardware configuration setting	JP3	Pins 2 & 3 closed
	Software configuration setting	JP3	Pins 1 & 2 closed
»	Factory configured - do not alter	JP5	Closed
»	Floppy drive interface enabled	JP6	Closed
	Floppy drive interface disabled	JP6	Open

PARALLEL PORT ADDRESS SELECTION
Setting		JP10	JP11
	LPT1 (378h)	Pins 2 & 3 closed	Pins 1 & 2 closed
»	LPT2 (278h)	Pins 1 & 2 closed	Pins 1 & 2 closed
	LPT3 (3BCh)	Pins 1 & 2 closed	Pins 2 & 3 closed
	Disabled	Pins 2 & 3 closed	Pins 2 & 3 closed

SERIAL PORT 1 & 2 ADDRESS SELECTION
Setting	JP7	JP8	JP9
Serial 1 COM1 / serial 2 COM2	Pins 1 & 2 closed	Pins 1 & 2 closed	Pins 1 & 2 closed
Serial 1 COM1 / serial 2 disabled	Pins 1 & 2 closed	Pins 2 & 3 closed	Pins 1 & 2 closed
Serial 1 COM2 / serial 2 COM1	Pins 1 & 2 closed	Pins 1 & 2 closed	Pins 2 & 3 closed
Serial 1 disabled / serial 2 COM1	Pins 2 & 3 closed	Pins 1 & 2 closed	Pins 2 & 3 closed
Serial 1 disabled / serial 2 COM2	Pins 2 & 3 closed	Pins 1 & 2 closed	Pins 1 & 2 closed
Serial 1 COM2 / serial 2 disabled	Pins 1 & 2 closed	Pins 2 & 3 closed	Pins 2 & 3 closed
Serial 1 disabled / serial 2 disabled	Pins 2 & 3 closed	Pins 2 & 3 closed	N/A

IDE INTERFACE ENABLE
Setting	JP2	JP4
Enable	Closed	Closed
Disabled	Open	Open