KW-801 Hard Disk/Floppy Controller Settings and Configuration

Data Bus	32-bit PCI
Card Size	Half-height, half-length card
Hard Drives supported	Up to 7 SCSI-2 devices
Floppy drives supported	None

CONNECTIONS
Function	Location	Function	Location
50-pin SCSI connector - internal	J1	2-pin connector - drive active LED	J4
50-pin SCSI connector - external	J2

USER CONFIGURABLE SETTINGS
Function		Label	Position
»	Active termination enabled	JP1	Closed
	Active termination disabled	JP1	Open
Note: When BOTH external AND internal devices exist, disable on-board termination jumper JP1 and insert the resister array RP1-RP3. This setting is used if controller lies within the device chain. When only external devices OR only internal devices exist, enable JP1 and remove resister arry RP1-RP3. This setting is used when controller is at one end of device chain. (Location of resistors RP1-RP3 is unidentified.)

PCI INTERRUPT SELECTION
Setting		JP2	JP3
»	INTA	Pins 2 & 3 closed	Open
	INTB	Pins 1 & 2 closed	Open
	INTC	Open	Pins 2 & 3 closed
	INTD	Open	Pins 1 & 2 closed