IFT-2000B (WITH OPTIONAL IFT-9031S/IFT9032S UPGRADE DAUGHTER BOARDS) Hard Disk/Floppy Controller Settings and Configuration

Data bus:	32-bit PCI
Size:	Three-quarter length, full-height card
Hard drive supported:	Up to fourteen Fast SCSI-2 devices Up to twenty-eight Fast SCSI-2 devices with upgrades
Floppy drives supported:	None

CONNECTIONS
Function	Location
4-pin connector - drive active LED	JP2
50-pin SCSI connector - internal channel 1	JP3
50-pin SCSI connector - internal channel 0	JP4
Connector to upgrade board	JP8
50-pin SCSI connector - external channel 0	JP17
9-pin serial port - external	JP20
Connector to upgrade board	JP26

UPGRADE BOARD CONNECTIONS
Function	Location
50-pin SCSI connector - internal channel 2	BJP1
50-pin SCSI connector - internal channel 3 (IFT-9032S only)	BJP2
Connector to controller main board	BJP3
Connector to controller main board	BJP4

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Factory configured - do not alter	JP1	pins 1 & 2 closed
»	Factory configured - do not alter	JP10	open
»	Factory configured - do not alter	JP11	open
»	Factory configured - do not alter	JP15	open

ONBOARD CPU SELECTION
CPU	JP9	JP18
486SX-25	pins 1 & 2 closed	pins 2 & 3 closed
486DX-25	pins 1 & 2 closed	pins 1 & 2, 3 & 4 closed
486SX-33	pins 2 & 3 closed	pins 2 & 3 closed
486DX-33	pins 2 & 3 closed	pins 1 & 2, 3 & 4 closed

DRAM CONFIGURATIONS
Size	Bank 0
2MB	(1) 512K x 36
4MB	(1) 1M x 36
8MB	(1) 2M x 36
16MB	(1) 4M x 36
32MB	(1) 8M x 36
Note: Minimum of 2 MBytes DRAM must be installed with/without parity function. Minimum of 4 MBytes DRAM suggested for RAID-3 and RAID-5 configurations.