DTC2290 (400395-89A1) Hard Disk/Floppy Controller Settings and Configuration

Card Type	Hard drive controller card
Hard Drives supported	Four IDE (AT) drives
Floppy drives supported	Two 360KB, 720KB, 1.2MB, or 1.44MB drives
Data Bus	16-bit ISA
Card Size	Three-quarter length, full-height card

CONNECTIONS
Function	Location	Function	Location
34-pin cable connector - floppy drive	J1	40-pin secondary IDE(AT) connector	J3
40-pin primary IDE(AT) connector	J2	4-pin connector - drive active LED	J4

USER CONFIGURABLE SETTINGS
Function		Label	Position
»	BIOS enabled	W3	Closed
	BIOS disabled	W3	Open
»	Floppy drive interface AT cable	W4	Open
	Floppy drive interface IBM cable	W4	Closed

PORT 1 DRIVE 0 HEAD MAPPING SETTINGS
Setting	W5
64- head mapping disabled	Open
64- head mapping enabled	Closed

PORT 1 DRIVE 1 HEAD MAPPING SETTINGS
Setting	W6
64- head mapping disabled	Open
64- head mapping enabled	Closed

PORT 2 DRIVE 0 HEAD MAPPING SETTINGS
Setting	W7
64- head mapping disabled	Open
64- head mapping enabled	Closed

PORT 2 DRIVE 1 HEAD MAPPING SETTINGS
Setting	W8
64- head mapping disabled	Open
64- head mapping enabled	Closed

BIOS ADDRESS SELECTION
Address	W1	W2
C800:0000h	Open	Open
D000:0000h	Open	Closed
D400:0000h	Closed	Closed
D800:0000h	Closed	Open