DTC6290-24, DTC6290E, DTC6290SE Hard Disk/Floppy Controller Settings and Configuration
DATA TECHNOLOGY CORPORATION
DTC6290-24, DTC6290E, DTC6290SE
Data bus: 32-bit, EISA
Size: Full-length,full-height card
Hard drives supported: Four 10-15Mbit/sec ESDI drives on the DTC6290E
Four 10-24Mbit/sec ESDI drives on the DTC6290-24
Four 10-15Mbit/sec ESDI drives and up to seven
SCSI devices on the DTC6290SE
Floppy drives supported: Three 360KB, 720KB, 1.2MB, or 1.44MB
Sector interleave: 1:1
CONNECTIONS | |
Function | Location |
34-pin control cable connector-hard drive | J1 |
20-pin data cable connector-drive 0 | J2 |
20-pin data cable connector-drive 1 | J3 |
34-pin data cable connector-floppy drive | J3A |
20-pin data cable connector-drive 2 | J4 |
20-pin data cable connector-drive 3 | J5 |
4-pin connector-drive active LED | J6 |
50-pin SCSI connector-external (DTC6290SE only) | J7 |
50-pin SCSI connector-internal (DTC6290SE only) | J8 |
USER CONFIGURABLE SETTINGS | |||
Function | Location | Setting | |
| » | Factory cofigured - do not alter | SW1/switch 1 | off |
| » | Factory cofigured - do not alter | SW1/switch 2 | off |
| » | Factory cofigured - do not alter | SW1/switch 3 | off |
| » | "Bad sector" list on cyl N-1 and cyl N-9 | SW1/switch 4 | on |
"Bad sector" list on cyl N-1 (N = # of Cyl.) | SW1/switch 4 | off | |
| » | Factory cofigured - do not alter | SW1/switch 5 | off |
| » | Floppy drive enabled | SW1/switch 6 | off |
Floppy drive disabled | SW1/switch 6 | on | |
| » | HD, FD and EISA register are accessible | SW1/switch 7 | off |
EISA registers are accessible only | SW1/switch 7 | on | |
| » | Port addresses are 1F0-1F7h and 3F2-3F7h | SW1/switch 8 | off |
Port addresses are 170-177h and 372-377h | SW1/switch 8 | on | |
My Books
