CSA-6400E Hard Disk/Floppy Controller Settings and Configuration
CMD TECHNOLOGY, INC.
CSA-6400E
Card Type | Hard drive controller |
Hard Drives supported | Four IDE (AT) drives |
Floppy drives supported | None |
Data Bus | 32-bit PCI |
Card Size | Half length, full-height |
CONNECTIONS | |||
Function | Location | Function | Location |
40-pin secondary IDE(AT) connector | CN1 | Drive active LED | CN3 |
40-pin primary IDE(AT) connector | CN2 | Paddle board connector | CN4 |
USER CONFIGURABLE SETTINGS | |||
Function | Label | Position | |
| » | DskChg (removable media) disabled | W2/1 | Open |
DskChg (removable media) enabled | W2/1 | Closed | |
| » | Base address enabled | W2/2 | Closed |
Base address disabled | W2/2 | Open | |
| » | PCI chip enabled | W2/3 | Open |
PCI chip disabled | W2/3 | Closed | |
| » | Factory configured - do not alter | W3/ 1 - 4 | Open |
| » | Factory configured - do not alter | W4/ 1 - 4 | Open |
| » | Factory configured - do not alter | W5 | Open |
| » | Normal base addressing (Legacy mode) enabled | W6/pins 2 & 3 | Closed |
| » | Normal base addressing (Legacy mode) enabled | W7/pins 2 & 3 | Closed |
Note:W6 & W7 pins 1 & 2 positions are not used. | |||
My Books
