BT-410CD Hard Disk/Floppy Controller Settings and Configuration
BUSLOGIC, INC.
BT-410CD
Data bus: | 32-bit VESA local bus |
Size: | Three quarter-length, full-height card |
Hard drive supported: | Four IDE (AT) interface drives, Two ATAPI devices |
Floppy drives supported: | Two 360KB, 720KB, 1.2MB, 1.44MB drives |
CONNECTIONS | |
Function | Location |
40-pin connector - IDE (AT) interface 1 | CN1 |
40-pin connector - IDE (AT) interface 2 | CN2 |
34-pin connector - Floppy drive interface | CN3 |
40-pin connector - ATAPI interface | CN4 |
4-pin connector - Drive active LED | JP1 |
4-pin connector - Speaker | JP2 |
USER CONFIGURABLE SETTINGS | |||
Function | Location | Setting | |
» | ATAPI mode enabled | JP3 | closed |
| ATAPI mode disabled | JP3 | open |
Note: If you are using two BT-410CD units in the same system, both cards must have ATAPI mode disabled. | |||
DRAM CONFIGURATION | ||
Size | Bank 0 | Bank 1 |
512KB | (2) 256K x 9 | NONE |
1MB | (2) 256K x 9 | (2) 256K x 9 |
2MB | (2) 1M x 9 | NONE |
2.5MB | (2) 1M x 9 | (2) 256K x 9 |
2.5MB | (2) 256K x 9 | (2) 1M x 9 |
4MB | (2) 1M x 9 | (2) 1M x 9 |
8MB | (2) 4M x 9 | NONE |
8.5MB | (2) 4M x 9 | (2) 256K x 9 |
8.5MB | (2) 256K x 9 | (2) 4M x 9 |
10MB | (2) 4M x 9 | (2) 1M x 9 |
10MB | (2) 1M x 9 | (2) 4M x 9 |
16MB | (2) 4M x 9 | (2) 4M x 9 |
My Books
