SIDE-3 Hard Disk/Floppy Controller Settings and Configuration
ACCULOGIC, INC.
SIDE-3
Data bus: | 16-bit, ISA |
Size: | Half-length, half-height card |
Hard drives supported: | Two IDE(AT) drives |
Floppy drives supported: | Two 360KB, 720KB, 1.2MB, or 1.44MB |
CONNECTIONS | |
Function | Location |
4-pin connector-Drive Active LED | J1 |
40-pin AT Interface (IDE) connector | J2 |
34-pin control cable connector-floppy drive | J3 |
ACCULOGIC, INC.
SIDE-3
. . .continued from previous page
USER CONFIGURABLE SETTINGS | ||
Function | Location | Setting |
Floppy drive port address is 3F0-3F7h | JP6 | open |
Floppy drive port address is 370-377h | JP6 | closed |
Hard drive port address is 1F0-1F7h | JP7 | open |
Hard drive port address is 170-177h | JP7 | closed |
Single speed floppy drives supported | JP8 | open |
Dual speed floppy drives supported | JP8 | closed |
Floppy drive precompensation is 125ns | JP9 | open |
Floppy drive precompensation is 187ns | JP9 | closed |
I/O Channel Ready signal disabled | JP10 | open |
I/O Channel Ready signal enabled | JP10 | closed |
IRQ14 STATUS | ||
Function | Jumper JP1 | Jumper JP2 |
IRQ14 normal | closed | open |
IRQ14 delayed until ACTIVE- signal is removed | open | closed |
MISCELLANEOUS TECHNICAL NOTES |
JP3, JP4, and JP5 are Not used. This controller has no on-board software. |
My Books
