MULTIVIDEO-MONO video card Settings and Configuration
STONE MICROSYSTEMS (AUSTRALIA) LIMITED
MULTIVIDEO-MONO
Card Type | Multi-video card |
Video Chip Set | Unidentified |
Maximum Video Memory | Unidentified |
I/O Options | Daisy chain connector, video modules (3), 78-pin cable connector |
Video Types Supported | Monochrome |
Highest Resolution Supported | Unidentified |
Data Bus | 16-bit ISA |
CONNECTIONS | |||
Function | Label | Function | Label |
Header connector to video module | CN1 | Header connector to video module | CN5 |
Daisy chain connector | CN2 | Header connector to video module | CN6 |
Header connector to video module | CN3 | Header connector to video module | CN7 |
Header connector to video module | CN4 | 78-pin cable connector | CN8 |
USER CONFIGURABLE SETTINGS | |||
Function | Label | Position | |
| » | First board in system | SW1/5 | On |
Second board in system | SW1/5 | Off | |
| » | VGA card not installed | SW1/6 | On |
VGA card installed | SW1/6 | Off | |
| » | ALT I/O address at 1F8 | SW1/7 | On |
ALT I/O address at 2F8 | SW1/7 | Off | |
| » | Factory configured - do not alter | SW1/8 | On |
Note: To avoid conflict with standard parallel and serial ports, SW1/7 should be left in the on position | |||
BASE I/O ADDRESS SELECTION | |||||
Setting | SW1/1 | SW1/2 | SW1/3 | SW1/4 | |
100h | On | On | On | On | |
| » | 120h | Off | On | On | On |
140h | On | Off | On | On | |
150h | Off | Off | On | On | |
180h | On | On | Off | On | |
1A0h | Off | On | Off | On | |
1COh | On | Off | Off | On | |
1E0h | Off | Off | Off | On | |
200h | On | On | On | Off | |
220h | Off | On | On | Off | |
240h | On | Off | On | Off | |
250h | Off | Off | On | Off | |
280h | On | On | Off | Off | |
2A0h | Off | On | Off | Off | |
2C0h | On | Off | Off | Off | |
2E0h | Off | Off | Off | Off | |
My Books
