lotus

previous page: 4B-11: I am using Windows V3.1 or WFWG V3.11. Can I use Peter Tattam'sTrumpet winsock software to connect to the NT V3.5 RAS using SLIP or PPP?What are the required configuration settings for NT and Trumpet tomake this work correctly?
  
page up: Windows NT Internet FAQ
  
next page: 4B-13: Where can I find a UUCP communications software package for Windows NT?

4B-12: How do I configure the Chameleon NetManage PPP TCP/IPto dial-in using PPP to a NT 3.5 RAS PPP server?




Description

This article is from the Windows NT Internet FAQ, by sscoggin@enet.net (Steve Scoggins) with numerous contributions by others.

4B-12: How do I configure the Chameleon NetManage PPP TCP/IPto dial-in using PPP to a NT 3.5 RAS PPP server?

Use the NetManage Chameleon version 4.01 or later.

Edit the slip.ini file and confirm that the PPP script contains the
following line:

"SCRIPT=-n"

Confirm that the PPP client configuration is correct, and that the
defaults are valid. The router and gateway entries should be all zero.
Double-check your IP address (if dynamic allocation, this should be
0.0.0.0). The subnet mask should be the default for your IP address
(if dynamic, this will be given during PPP negotiations).
Verify that the login name, password, and domain name are all correct.

If your machine is not physically connected to a network, make sure that
the MS Loopback Adapter is installed. (That is, if you are using RAS as
your only network connection.) After adding the MS Loopback Adapter,
the network bindings will be reconfigured. You will be asked for TCP/IP
settings for the adapter. Enter your IP address and subnet mask.
Leave the default gateway clear.

Be sure that the Remote Access Service is installed. Select enable
receiving calls. Select Control panel, then Remote Access Service, then
Configure, then Network Settings enable TCP/IP in the middle section.
Configure this and allow access to the entire network (this may not be
necessary). Configure the addresses here (I used a static allocation).
Enable a requested address, if you want the WFW machine to be able to
request a specific address.

Turn on IP routing and RAS forwarding.
Using the Registry Editor, set "IPEnableRouter" (REG_DWORD) to 0x1
in order to enable IP routing.

\HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\Tcpip\Parameters

IPEnableRouter REG_DWORD 1


Note that NTAS users can check this box in
\ControlPanel\Network\TCP/IP\Configure\Advanced

If other clients on the local subnet will be using the NT RAS
server as a router, you should also set the following:

\HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\RasArp\Parameters

You may need to add the registry key entry "DisableOtherSrcPackets".

Set "DisableOtherSrcPackets" (REG_DWORD) to 0x0 to enable the IP packets
from the other clients on the local ethernet to pass through the
NT gateway. You can also set it to 0x1 to disable other clients IP
packets.



 

Continue to:













TOP
previous page: 4B-11: I am using Windows V3.1 or WFWG V3.11. Can I use Peter Tattam'sTrumpet winsock software to connect to the NT V3.5 RAS using SLIP or PPP?What are the required configuration settings for NT and Trumpet tomake this work correctly?
  
page up: Windows NT Internet FAQ
  
next page: 4B-13: Where can I find a UUCP communications software package for Windows NT?