 |
 |
Articles / TULARC / PC info / Network Cards / P / |  |
|
|
||||
|
|
|||
|
|
|||
|
||||
|
|
||||
|
   |
|
||
|
PD1516PLUS-F (FIBER OPTIC) Network Card Settings and Configuration |
|
||
|
||||
|
|
|
||
|
||||
|
|
|
|
||
|
||
|
|
|
|
||
|
|
||
|
||
|
|
|
|
||
|
||
PURE DATA LTD.
PD1516PLUS-F (FIBER OPTIC)
|
NIC Type |
ARCnet |
|
Transfer Rate |
2.5Mbps |
|
Data Bus |
16-bit ISA |
|
Topology |
Star Linear Bus |
|
Wiring Type |
50/62.5/100 m Fiber optic cable |
|
Boot ROM |
Available |
|
CONFIGURATION MEMORY CLEAR |
||
|
Clear |
JP1 |
|
|
» |
Normal operation |
Open |
|
|
Clear all addresses and settings from memory |
Closed |
|
CARDS INSTALLED |
||||
|
Card number |
JP2A |
JP2B |
JP2C |
JP2D |
|
1 |
Closed |
Open |
Open |
Open |
|
2 |
Open |
Closed |
Open |
Open |
|
3 |
Open |
Open |
Closed |
Open |
|
4 |
Open |
Open |
Open |
Closed |
Note:If there is only one NIC installed in a system, set this option to the "1" position. If this NIC is the second NIC to be installed in a system, set this option to the "2" position and so on. |
||||
|
COMPATIBILITY MODE |
||
|
Condition |
JP3 |
|
|
» |
Compatibility mode disabled |
Open |
|
|
Compatibility mode enabled |
Closed |
Note: Compatibility mode should be enabled only when the NIC is installed in a system using a Suntac 286 chipset. |
||
|
CONNECTORS |
|
|
Connectors |
Definition |
|
COM2 connector |
Transmit |
|
COM1 connector |
Receive |
|
DIAGNOSTIC LED(S) |
|||
|
LED |
Color |
Status |
Condition |
|
LED1 |
Red |
Blinking |
I/O bus activity |
|
LED1 |
Red |
Off |
No I/O bus activity |
|
LED2 |
Green |
On |
Data is being transmitted or received |
|
LED2 |
Green |
Blinking |
No network activity detected, or bad connection |
|
|
|
|
 |
|