G/EtherNet 8 Adapter Network Card Settings and Configuration

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	8-bit ISA
Topology	Linear Bus
Wiring Type	RG-58A/U 50ohm coaxial
Boot ROM	Available

INTERRUPT REQUEST
IRQ		JP1	JP2	JP3	JP4	JP5	JP6
	2	Closed	Open	Open	Open	Open	Open
	3	Open	Closed	Open	Open	Open	Open
	4	Open	Open	Closed	Open	Open	Open
»	5	Open	Open	Open	Closed	Open	Open
	6	Open	Open	Open	Open	Closed	Open
	7	Open	Open	Open	Open	Open	Closed

I/O BASE ADDRESS
Address		SW1/1	SW1/2	SW1/3
	260-27F	On	On	On
	280-29F	Off	On	On
»	2A0-2BF	On	Off	On
	2E0-2FF	Off	Off	On
	300-31F	On	On	Off
	320-33F	Off	On	Off
	380-39F	On	Off	Off
	3E0-3FF	Off	Off	Off

BOOT ROM ADDRESS
PROM Address	SW1/4	SW1/5	SW1/6
C4000-C7FFF	On	On	On
C8000-CBFFF	Off	On	On
CC000-CFFFF	On	Off	On
D0000-D3000	Off	Off	On
D4000-D7000	On	On	Off
D8000-DBFFF	Off	On	Off
DC000-DFFFF	On	Off	Off
Disabledd	Off	Off	Off

WAIT STATE
Setting		SW1/7
»	Zero wait states disabled	Off
	Zero wait states enabled	On

MISCELLANEOUS NOTES

Different drivers must be used for the National & the Fujitsu chipset cards, & are not interchangeable. Fujitsu adapters may be used for either 8 or 16 bit Fujitsu cards. While the National chipset cards require a different driver for an 8 or 16 bit card.