MAGNUM FT1/FT1A/FT10 Network Card Settings and Configuration

Card Type	Ethernet Transceiver
NIC Type	Ethernet
Maximum Onboard Memory	Unidentified
Boot ROM	Not available
Network Transfer Rate	10Mbps
Topology	Linear Bus, Star
Wiring Type	AUI transceiver via DB-15 port, Fiber optic
Data Bus	External

CONNECTIONS
Function	Label	Function	Label
AUI transceiver port	CN1	ST transmit fiber connector	CN3
ST receive fiber connector	CN2

USER CONFIGURABLE SETTINGS
Function		Label	Position
»	SQE disabled	SW1	Off
	SQE enabled	SW1	On

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
LED1	Unidentified	On	Power is on & network connection is good
LED1	Unidentified	Off	Power is off & network connection is broken
LED2	Unidentified	On	Collision detected on network
LED2	Unidentified	Off	No collision detected on network
LED3	Unidentified	Blinking	Data is being transmitted
LED3	Unidentified	Off	Data is not being transmitted
LED4	Unidentified	On	Jabber condition detected
LED4	Unidentified	Off	No jabber condition detected
LED5	Unidentified	Blinking	Data is being received
LED5	Unidentified	Off	Data is not being received
LED6	Unidentified	On	Power is reaching the unit
LED6	Unidentified	Off	Power is not reaching the unit
LED7	Unidentified	On	SQE is enabled
LED7	Unidentified	Off	SQE is disabled

MISCELLANEOUS TECHNICAL NOTES

The FT1 and the FT1A use multi-mode fiber optic cable and the FT10 uses single-mode.