2000C/EN-3360 V2.4 Network Card Settings and Configuration

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	16-bit ISA
Topology	Linear Bus
Wiring Type	RG-58A/U 50ohm coaxial AUI transceiver via DB-15 port
Boot ROM	Available

COMPATIBILITY MODE
Setting		JP1
»	Disabled	Pins 1 & 2 closed
	Enabled	PIns 2 & 3 closed
Note:On some systems the data bus timing is not truly IBM PC/AT compatible. If the card is not

INTERRUPT SETTINGS
IRQ	JP2A	JP2B	JP2C	JP2D	JP2E	JP2F	JP2G	JP2H	JP2I	JP2J	JP2K
2/9	Open	Open	Open	Open	Open	Closed	Open	Open	Open	Open	Open
3	Open	Open	Open	Open	Open	Open	Open	Open	Open	Open	Closed
4	Open	Open	Open	Open	Open	Open	Open	Open	Open	Closed	Open
5	Open	Open	Open	Open	Open	Open	Open	Open	Closed	Open	Open
6	Open	Open	Open	Open	Open	Open	Open	Closed	Open	Open	Open
7	Open	Open	Open	Open	Open	Open	Closed	Open	Open	Open	Open
10	Open	Open	Open	Open	Closed	Open	Open	Open	Open	Open	Open
11	Open	Open	Open	Closed	Open	Open	Open	Open	Open	Open	Open
12	Open	Open	Closed	Open	Open	Open	Open	Open	Open	Open	Open
14	Open	Closed	Open	Open	Open	Open	Open	Open	Open	Open	Open
15	Closed	Open	Open	Open	Open	Open	Open	Open	Open	Open	Open

I/O BASE ADDRESS
Address		JP2L	JP2M
»	300h	Closed	Closed
	320h	Closed	Open
	340h	Open	Closed
	360h	Open	Open

BOOT ROM
Setting		JP3
»	Disabled	Open
	Enabled	Closed

BOOT ROM ADDRESS
Address		JP4A	JP4B	JP4C	JP4D
	C0000h	Closed	Closed	Closed	Closed
	C4000h	Closed	Closed	Closed	Open
»	C8000h	Closed	Closed	Open	Closed
	CC000h	Closed	Closed	Open	Open
	D0000h	Closed	Open	Closed	Closed
	D4000h	Closed	Open	Closed	Open
	D8000h	Closed	Open	Open	Closed
	DC000h	Closed	Open	Open	Open

CABLE TYPE
Type		JP10	JP12
»	RG-58A/U 50ohm coaxial	Pins 2 & 3 Closed	Pins 2 & 3 Closed
	AUI transceiver via DB-15 port	Pins 1 & 2 Closed	Pins 1 & 2 Closed

FACTORY CONFIGURED SETTINGS
Jumper	Setting
JP6	Unused

CONNECTORS
Setting	Location
External power LED.	JP11