ACTIONTEC ELECTRONICS, INC.
DATALINK 33.6
Card Type | Fax, Modem (asynchronous) |
Chip Set | Unidentified |
Maximum Data Rate | 33.6Kbps |
Maximum Fax Rate | 14.4Kbps |
Data Bus | PCMCIA Type II |
Fax Class | Class I & II |
Data Modulation Protocol | Bell 103/212A ITU-T V.21, V.22, V.22bis, V.23, V.32, V.32bis, V.34 |
Fax Modulation Protocol | ITU-T V.17, V.21CH2, V.27ter, V.29 |
Error Correction/Compression | MNP5, V.42, V.42bis |
ACTIONTEC-ELECTRONICS-INC-Fax-Modem-asynchronous-D-132
SUPPORTED COMMAND SET |
Basic AT Commands |
AT, A/ |
A, E, H, V, W, Z |
&D, &F, &W |
S Registers |
S0, S6, S7, S8 |
Note: Please see MHI Help file for full command documentation. |
Proprietary AT Command Set
DIAL | |
Type: | Immediate |
Format: | AT [cmds] D<#> [cmds] |
Description: | Dials telephone number according to any modifiers included in the string |
Note: | Any combination of modifiers can be used to produce the desired dial functions in sequence. |
Modifier | Function |
T | Tone dialing enabled |
P | Pulse dialing enabled |
, | Dialing paused for amount of time specified in S8 register |
W | Dialing resumed following dial tone detection |
SPEAKER VOLUME | |
Type: | Configuration |
Format: | AT [cmds] Ln [cmds] |
Description: | Controls speaker volume |
Command | Function |
L0 | Speaker volume disabled |
í L2 | Speaker volume enabled |
SPEAKER MODE | |
Type: | Configuration |
Format: | AT [cmds] Mn [cmds] |
Description: | Selects various speaker options |
Command | Function |
M0 | Speaker disabled |
í M1 | Speaker enabled until carrier signal detected, off for transmission |
M2 | Speaker enabled |
DATA CARRIER DETECT (DCD) | |
Type: | Configuration |
Format: | AT [cmds] &Cn [cmds] |
Description: | Selects whether the DCD option is enabled or disabled |
Command | Function |
&C1 | DCD enabled after carrier signal detected |
MISCELLANEOUS TECHNICAL NOTES |
The PCMCIA fax/modem requires an analog RJ-11 telephone line. A PBX or digital phone line may damage the PCMCIA fax/modem or telephone equipment. |