UNIDENTIFIED
GW-106V/GW-106V1
Data bus: | 16-bit ISA |
Size: | Three-quarter length, full-height card |
Hard drive supported: | Two ST506/412 drives |
Floppy drives supported: | 360KB, 720KB, 1.2MB, 1.44MB |
CONNECTIONS | |
Function | Location |
34-pin control cable connector - floppy drive | J1 |
20-pin data cable connector - drive 1 | J3 |
20-pin data cable connector - drive 0 | J4 |
34-pin control cable connector - hard drive | J5 |
4-pin connector - drive active LED | JP1 |
USER CONFIGURABLE SETTINGS | |||
Function | Location | Setting | |
» | Latched hard drive mode enabled | JP2/A | open |
Non-latched hard rive mode enabled | JP2/A | closed | |
» | Four byte ECC enabled | JP2/B | open |
Reserved | JP2/B | closed | |
» | Caching enabled | JP2/C | open |
Caching disabled | JP2/C | closed | |
» | Factory configured - do not alter | JP2/D | N/A |
» | Floppy drive interface primary address select | JP3 | open |
Floppy drive interface alternate address select | JP3 | closed |
USER CONFIGURABLE SETTINGS(CONTINUED) | |||
Function | Location | Setting | |
» | Hard drive interface primary address select | JP4 | open |
Hard drive interface alternate address select | JP4 | closed | |
» | Bracket ground disabled | JP5 | open |
Bracket ground enabled | JP5 | closed | |
» | Floppy drive interface single speed enabled | JP6 | open |
Floppy drive interface dual speed enabled | JP6 | closed | |
Note: The location of jumper JP5 is unspecified in manufacturer documentation. |